The Universal Selection Source: Plastics & Elastomers

Industry News

Reifenhäuser Introduces EVOLUTION Line Technology for European Plastic Film Industry

Published on 2011-08-29. Author : SpecialChem

Reifenhäuser Kiefel launches new EVOLUTION line technology for European traders. Universal low-temperature screws and rheologically optimized blown film die-heads featuring short residence times, in combination with the newly developed intuitive EVOLUTION C line control system allow shortest conversion times while maintaining simple handling of the line. This is achieved with the large new 24" touch screen which provides for an especially user-friendly and easily comprehensible operation. Start-up and conversion times can additionally be reduced and the amount of scrap material and maintenance minimized.

Automation systems are not only used in modern production lines but are installed more and more also in existing equipment where they significantly contribute to an increase in efficiency. Finally, the EVOLUTION line technology by Reifenhäuser Kiefel Extrusion allows handling raw materials responsively and efficiently, to the benefit of the producers and lasting but not least the consumers.

About Reifenhäuser Kiefel

Reifenhäuser Kiefel with over 60 years of experience and more than 7.000 installed extruders, Reifenhäuser Kiefel Extrusion is one of the largest providers of machines and lines for the extrusion of sophisticated thermoplastic materials worldwide. With the broadest scope of products available in the plastic sector the machines of Reifenhäuser Kiefel can produce the widest range of applications from simple films to sophisticated technical films with barrier properties as well as agricultural films.

Source: Reifenhäuser Kiefel


Be the first to comment on "Reifenhäuser Introduces EVOLUTION Line Technology for European Plastic Film Industry"

Leave a comment





Your email address and name will not be published submitting a comment or rating implies your acceptance to SpecialChem Terms & Conditions
Velox

Online Course

Jeffrey A. Jansen
9 Days left to register

Thursday Feb 18 2016

By Jeffrey A. Jansen

Boost your plastics performance by extracting the most out of DSC curves: phase transitions, crosslinking, additive depletion, aging...

34 Read More
Back to Top