The Universal Selection Source:
Plastics & Elastomers

Improved Process for Injection Molding of Thin-wall Parts

SpecialChem / Dec 17, 2012

As plastic freezes in the mold cavity, conventional high variable pressure injection molding machines increase injection pressure (to maintain a substantially constant volumetric flow rate due to the smaller cross-sectional flow area). Increasing the pressure, however, has both cost and performance downsides. As the pressure required to mold the component increases, the molding equipment must be s

Be the first to comment on "Improved Process for Injection Molding of Thin-wall Parts"

Leave a comment

Your email address and name will not be published submitting a comment or rating implies your acceptance to SpecialChem Terms & Conditions
Silon Safe Pipes and Safe Water
The Chemicals Sales & Marketing Toolbox
Channel Alerts

Receive weekly digests on hot topics

Back to Top