OK
The Universal Selection Source:
Plastics & Elastomers
Article

Who should make the Robot Gripper?

SpecialChem / Sep 6, 2006

Robots designed to unload injection molding machines have become increasingly common over the last 20 years, but their capability is frequently under-delivered due to poor engineering of the gripper (end of arm tooling). By integrating the mould design with the robot gripper design a seamless solution can be developed and produced that can be trialled together as a production system at the time of the first trial of a new mould.

Be the first to comment on "Who should make the Robot Gripper?"

Leave a comment





Your email address and name will not be published submitting a comment or rating implies your acceptance to SpecialChem Terms & Conditions
Improve the durablility of Polyurethane with Eternacoll Polycarbonate diols
Channel Alerts

Receive weekly digests on hot topics

Back to Top