AKROLOY® PA GF 30 is a partially aromatic Polyamide (PA) blend based on a semi-crystalline PA 6.6 and an amorphous CoPA (PA 6I/6T), reinforced with 30% glass fiber. Offers increased toughness and... view more

AKROLOY® PA GF 40 is a partially aromatic Polyamide (PA) blend based on a semi-crystalline PA 6.6 and an amorphous CoPA (PA 6I/6T), reinforced with 40% glass fiber. Offers increased toughness and... view more

AKROLOY® PA GF 50 is a partially aromatic Polyamide (PA) blend based on a semi-crystalline PA 6.6 and an amorphous CoPA (PA 6I/6T), reinforced with 50% glass fiber. Offers increased toughness and... view more

AKROLOY® PA GF 60 is a partially aromatic Polyamide (PA) blend based on a semi-crystalline PA 6.6 and an amorphous CoPA (PA 6I/6T), reinforced with 60% glass fiber. Offers increased toughness and... view more

AKROMID® HI A3 GF 30 S1 is an impact modified Polyamide 6-6 (PA 6-6) grade reinforced with 30% glass fiber. Offers excellent cold-impact strength, stiffness and good balance of properties at higher... view more

Ashlene® 520-13G is a cost savings, general purpose, heat stabilized, lubricated polyamide 66 (Nylon 66) grade reinforced with short glass fiber. Exhibits excellent thermal and dimensional stability... view more

Ashlene® 520-33G is a cost savings, general purpose, heat stabilized, lubricated polyamide 66 (Nylon 66) grade reinforced with short glass fiber. Exhibits excellent thermal and dimensional stability... view more

Ashlene® 520-40G is a cost savings, general purpose, heat stabilized, lubricated polyamide 66 (Nylon 66) grade reinforced with short glass fiber. Exhibits excellent thermal and dimensional stability... view more

Ashlene® 520-50G is a cost savings, general purpose, heat stabilized, lubricated polyamide 66 (Nylon 66) grade reinforced with short glass fiber. Exhibits excellent thermal and dimensional stability... view more

Ashlene® 525LD-13G is a high impact polyamide 66 (Nylon 66) grade reinforced with glass fiber and other modifications. Is suitable for processing by injection molding. Suitable for very low warpage... view more